DWL-2100AP
Contents
D-Link AirPlus XtremeG
Default Settings
On first startup it assigns 192.168.0.50 (subnet 255.255.255.0) to the ethernet port. The webinterface is accessed on the normal port at this address.
Username: admin
Password: <blank>
Web Interface
This is split into 5 tabs along the top of the page
Home
Wizard - Deals with setting up basic settings on access point for easy use
Wireless - Wireless options including SSID, Channel and encryption
LAN - IP settings for wired network.
- Get IP From - Static (Manual) / Dynamic (DHCP)
- IP address
- Subnet Mask
- Default Gateway
Advanced
Performance - Includes
- Data rate
- Beacon interval
- Transmit power
Filter - Enable filtering by MAC address and ability to partition WLAN and LAN and disable access between them
Grouping - AP Grouping Settings (For AP Mode Only)
DHCP Server - Dynamic Pool Settings / Static Pool Settings / Current IP Mapping List
Multi-SSID - Enable Multi-SSID and Enable VLAN State
Tools
Admin - Login, Console access and SNMP
System - Restart and restore factory defaults
Firmware - Update firmware
Cfg File - Update config
Status
Device Info - Firmware, IP addresses, wireless information
Stats - Wireless stats
Client Info - Table of connected clients
Log - System Log
Help
Help pages
Hardware
- D-Link hardware revision A4 firmware revision 2.20eu
- Atheros - AR2313A-001 - B52307B - 0635 - TAIWAN
- ESMT - M12L128168A-7T - AZG1P536E - 0610
- 16mb SDRAM - datasheet
- Spansion - S29GL032M90TFIR4 - 0634CRM-K - © 04-Spansion
- 4mb flash -Product website
- IC+ - IP101A-LF - 0640C15 - KPF0005.1
- Single port 10/100 Fast Ethernet Transceiver - datasheet
Serial Console
JP2 on the board is a serial connection as per other D-Link products. Using the pinout on http://wiki.openwrt.org/OpenWrtDocs/Hardware/D-Link and a level convertor (as per fon etc.) serial console access was accessible. With settings 9600 8-N-1, open serial connection and as soon as power is applied to AP, hit the escape key lots :) If you didn't catch it try again. You should be presented with something like this
[Boot]: [Boot]: ? ? - print this list @ - boot (load and go) p - print boot params c - change boot params e - print fatal exception v - print version B - change board data S - show board data n netif - print network interface device address $dev(0,procnum)host:/file h=# e=# b=# g=# u=usr [pw=passwd] f=# tn=targetname s=script o=other boot device: tffs=drive,removable file name: /tffs0/vxWorks Boot flags: 0x02 - load local system symbols 0x04 - don't autoboot 0x08 - quick autoboot (no countdown) 0x20 - disable login security 0x40 - use bootp to get boot parameters 0x80 - use tftp to get boot image 0x100 - use proxy arp available boot devices:Enhanced Network Devices ae1 tffs
If you don't press escape and hit enter once it's finished loading you get a dlink login prompt with the same access as per telnet/ssh.